SlabPop™ Quick Start Guide

Download the SlabPop™ app for iPhone or Android. You'll use it to pair, configure, and manage your device.

• Download on the App Store
• Get it on Google Play

Or visit www.slabpop.com from your phone.

The whole setup takes about 2 minutes.

1. Plug your SlabPop™ into a USB power source.
2. Wait until the screen shows setup instructions.
3. Open the SlabPop™ app on your phone.
4. Go to Devices → Add Device.
5. Select your SlabPop™ from the list of nearby devices.
6. Connect to Wi‑Fi and enter your password.
7. Customize your display settings.
8. Complete pairing in the app.
9. When your card appears on the screen, setup is complete.

• Keep your phone near the device during setup.
• Make sure Bluetooth is enabled on your phone.
• If your network is dual-band, use the 2.4 GHz Wi‑Fi network — SlabPop devices don't support 5 GHz.
• Allow the SlabPop app permission to use Bluetooth and your local network when prompted.

Device doesn't appear in the app. Make sure it's plugged in and the screen is showing setup instructions. Confirm Bluetooth is on, then pull down to refresh in the app's Devices tab.

Wi‑Fi connection fails. Double-check the password and confirm you're connecting to a 2.4 GHz network. Some routers broadcast 2.4 and 5 GHz under the same name — if so, temporarily disable 5 GHz or create a separate 2.4 GHz SSID for setup.

Need to reset Wi‑Fi. Open the app, long-press your device in the Devices list, and tap Reset Wi‑Fi Settings. The device will return to setup mode.

For a full FAQ, visit our FAQ page.